 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
davevanlanen(at)sbcglobal
Guest
|
 Posted: Fri Feb 10, 2006 8:41 pm Post subject: ZAC Construction Manual Question |
 |
|
Can someone please explain item 6 on p. 18 of the Construction Manual? It
states the following:
"Bolt holes, (AN / MS hardware) drill the bolt holes first, then radius the
part (radius is from the center of the bolt hole to the edge of the part).
Position the part with reference to the bolt hole, then mark the rivet
line."
I'm not able to picture what the building scenario that these instructions
apply to, or what is being accomplished.
Thanks,
Dave Van Lanen
Madison, WI
601 XL
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
| Back to top |
|
 |
Ron Lendon
Joined: 10 Jan 2006
Posts: 685
Location: Clinton Twp., MI
|
| Posted: Fri Feb 10, 2006 10:34 pm Post subject: Re: ZAC Construction Manual Question |
|
|
Dave,
To me it means drill the bolt holes first, then trim the part. Look at the lower hinge braket of the rudder (601XL) if you make that part out of flat stock it is easier to put the holes in before forming or trimming. The radius they are talking about is the outer trim around the hole. Once the part is positioned (hinge is lined up and so is the rudder) then layout the rivet line.
Hope that helps,
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
_________________
Ron Lendon
WW Corvair with Roy's Garage 5th bearing
CH 601 XLB
N601LT - Flying
http://www.mykitlog.com/rlendon
Corvair Engine Prints:
https://sites.google.com/site/corvairenginedata/ |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
