aaaron(at)tvp.com.au
Guest
|
 Posted: Sun Jun 17, 2007 7:07 pm Post subject: Lightspeed/EIS |
 |
|
Hi all
I started my engine first time last weekend. All good except the
Manifold Pressure and Ignition Timing readouts from the lightspeed
plasma 3 box to my EIS4000 were goofy. I get a reading but its
obviously not reality. I asked Sandy at GRT and she said that I can't
get MP from the lightspeed onto the EIS. But I do get a readout so
wonder why I can't just calibrate it using the right SF and OfsetF? The
lightspeed manual says the unit outputs 0.01 Volts per inch Hg (MP) and
0.01 Volts per degree (ignition advance). Has anyone hooked up their
EIS direct to the lightspeed unit? I know I can buy a separate
"microvolt meter" from Lightspeed but don't want to do that. I've
emailed Klaus at lightspeed to see whether he knows if the EIS is
compatible but received no reply after a week. Just want to confirm it
can't be done (and understand why) before I order a separate manifold
pressure sensor from Sandy. Thanks again for your collective advice.
Allan
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
