cffd(at)pgrb.com
Guest
|
 Posted: Wed Aug 01, 2007 6:53 pm Post subject: 701 Takeoff w flaps701 |
 |
|
Mil,
I have 12 inches of clearance with a 64 inch prop. Block is solid, only 8
holes for bolts. Still have the same prop but considering a 62x34 Tennessee
prop. Top cowl has 6-32 screws to top nose bowl and in front of windshield.
I pull the hinge wires too. The hinge wires have a 90 deg bend in the front
which is secured with a piece of hinge under a cowl screw.
Chuck
Time: 12:13:26 PM PST US
From: "milreed" <milreed(at)wildblue.net>
Subject: Re: Re: 701 Takeoff w flaps701 Takeoff w flaps
Chuck
I saw that block on your web site. I was thinking, was done for prop
clearance, since we were last discussing this subject. I guess it is a
drilled out aluminum block with lightening holes Or ? Did you get a new
prop? My 2200 arrives 9/8/07 and we will pick it up in Fresno with the
FWF kit. They don't have a cowling, so I plan to make that part. I see
hinges on the sides of yours, do you just pull the rod out to take it
off? Oil door ?? I will make it like yours so send full set of plans (
just kidding). Mucho preguntas!
Mil
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
