Matronics Email Lists :: View topic - F-904H Center Section Side Plate

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

F-904H Center Section Side Plate

Matronics Email Lists Forum Index -> RV-List

View previous topic :: View next topic

Author Message

brown_rj(at)bellsouth.net
Guest

Posted: Sat Feb 18, 2006 10:55 am Post subject: F-904H Center Section Side Plate

I think my right 904H might have been drilled backward. It appears on dwg 23 coordinates 3.5, and C, that the top of the spar flange has a bevel on the front flange. The 904H has this same bevel. My left side matches the  dwg, but the right has the  bevel on the aft flange of the spar. I matched up the bevels not paying attention to the orientation and matched drilled. Now I notice the spacer will not come out of the slot between the two spars. If I flip the 904H over, the slot works fine, and all is well. The issue now is the hole spacing. the front is supposed to have 24 holes and the rear flange 25 according to dwg 16. I can't simply drill new holes as they will elongate the current ones, any ideas, thoughts? The left side is correct.. spar flange serial numbers and orientation marks from vans is correct..

- The Matronics RV-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum