Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

throttle, etc cables

Matronics Email Lists Forum Index -> RV10-List

View previous topic :: View next topic

Author Message

tdawson-townsend(at)auror
Guest

Posted: Sun Sep 23, 2007 12:12 pm Post subject: throttle, etc cables

I ran my throttle, prop, and mixture cables over the bottom bar of the engine mount, like shown on the FF plans.  Seems like not a lot of room in there and potential for rubbing.  Did other folks do the same, or let the cables go under the bottom bar of the engine mount?

 

 Thanks,

 

 TDT

      [quote][b]

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

VHMUM(at)bigpond.com
Guest

Posted: Sun Sep 23, 2007 12:25 pm Post subject: throttle, etc cables

My cables were not long enough as supplied by FF  kit and using the pre punched holes in firewall so I made new holes in the fire  wall and run the cables under the bar and clamped them.

  

 regards Chris

 [quote]   ---

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

bgill1(at)charter.net
Guest

Posted: Sun Sep 23, 2007 5:51 pm Post subject: throttle, etc cables

I ran mine under the bar – but also did not have enough cable length. I am using a canted center panel that my knobs mount on - this takes up an extra inch or so leaving me buying a new set of cables. But like you,  It looked like over time it might get a little close – so I didn’t want to take a chance.  

   

Byron  

Wrapping up the panel install   

N253RV Assigned   

   

--

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV10-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum