jkafka(at)trojanuv.com
Guest
|
 Posted: Thu Oct 11, 2007 6:27 am Post subject: Re; Wing Spars Done! Bolts? |
 |
|
Thanks to all for the feedback on bolt direction. Clearly it will be a while before I need to make a decision!
I, too used a variant of the arbor press method of rivet smashing, and I think the results were quite good (although I did manage to acquire more rivet-removing skills than I had hoped!)
Jeff Kafka
601XL Plans
Tail, Flaps, Ailerons, Spars Done
Working on Ribs & Assembling Wings
Do Not Archive
This message (including any attachments) contains confidential
and/or proprietary information intended only for the addressee.
Any unauthorized disclosure, copying, distribution or reliance on
the contents of this information is strictly prohibited and may
constitute a violation of law. If you are not the intended
recipient, please notify the sender immediately by responding to
this e-mail, and delete the message from your system. If you
have any questions about this e-mail please notify the sender
immediately.
[quote][b]
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
