Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Mod 74 Again

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Europa-List
View previous topic :: View next topic  
Author Message
Troy Maynor



Joined: 10 Jan 2006
Posts: 162

PostPosted: Wed Oct 17, 2007 7:12 pm    Post subject: Mod 74 Again Reply with quote

Hi All,
I have received my Mods 52 and 74. Reading over # 74 a question comes to
mind. Can anyone tell me why I was under the impression the new rear wing
pin was going to be threaded through the flap attaching point, then a nut,
within the wing. Was this an early speculation of a possible fix? I plan to
start the socket and tie bar portion of mod 52 before getting into the wing.
Troy Maynor
N120EU Europa Monowheel Classic
Left to finish:
Paint,(some) interior,engine install, (some) wiring.
Weaverville, NC USA


- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List



winmail.dat
 Description:

Download
 Filename:  winmail.dat
 Filesize:  1.8 KB
 Downloaded:  494 Time(s)

Back to top
View user's profile Send private message Send e-mail
ptag.dev(at)tiscali.co.uk
Guest





PostPosted: Wed Oct 17, 2007 10:40 pm    Post subject: Mod 74 Again Reply with quote

Hi! Troy
There is a mod. Variant which allows access through the flap close out. I requested it be considered but was “knocked back “ …now having invaded mine the variant has been produced. However you need to clearly establish that the threaded hole is absolutely central to the sandwich stack (including the edge of the flap hinge bracket to be “eyed” up also in line with the edge of the same stack since the threaded hole also goes through it. To remedy any deficiency with these items would IMHO be very difficult through the flap close out.
Regards
Bob Harrison G-PTAG . [list][list]
--


- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Europa-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group