Matronics Email Lists :: View topic - Auto Pilot servo mounting

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Auto Pilot servo mounting

Matronics Email Lists Forum Index -> Lightning-List

View previous topic :: View next topic

Author Message

14az(at)mysprocketmail.co
Guest

Posted: Thu Oct 25, 2007 5:36 pm Post subject: Auto Pilot servo mounting

These are pictures of where I wound up mounting the  roll & pitch servos.  After 4 months of thinking I found this system  was very easy and completely out of the way.  For both roll and pitch I  made the same flat plate and mounted them to the wing root indent and to the  frame for the rear baggage floor. I attached the servos to the flat plat studs  with washers and nylocks.  Very easy to install or remove.   Both  bolt to the respective tubes. On the roll if you install the AN3 bolt that holds  the solid aluminum receiver for the rod end horizontal instead of vertical the  servo rod end will fit there fine.  I had already put mine vertical so I  had to shorten the servo push pull tube to make it fit.   Johnny

- The Matronics Lightning-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Lightning-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Lightning-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum