dino.agnes(at)internode.o Guest
|
Posted: Thu Dec 27, 2007 4:51 pm Post subject: Tailplane torque tube proposed mod for replacement of quarte |
|
|
Gentlemen,
Here is my proposed mod.
Turn insert nut diameter 34mm and 19mm thick. Cut in half, 2 small blobs of
silastic to increase diameter to 35mm. This will hold insert in tube due to
compression of silicon. Tap bolt hole to suit eg. 1/4 af. Make sure a bolt
plain shank long enough so that no thread is in contact with tubes.
Saddle washers turned to o.d. of tubes. 16mm dia and 1/4 inch thick at
smallest radius.
Loctite or wire-lock bolts to suit.
If you want to discuss this with me, my phone number in Australia
0882773423. Get the time difference right.
Cheers,
John Baker,
Kit #181
730 hrs flying time.
N.b. detailed drawings were sent to Europa and PFA.
| - The Matronics Europa-List Email Forum - | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Europa-List |
|
Description: |
|
Filesize: |
38.73 KB |
Viewed: |
158 Time(s) |
|
Description: |
|
Filesize: |
39.06 KB |
Viewed: |
157 Time(s) |
|
Description: |
|
Filesize: |
45.05 KB |
Viewed: |
153 Time(s) |
|
|
|