Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Sleeves on cable

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Zenith-List
View previous topic :: View next topic  
Author Message
zsmith3rd(at)earthlink.ne
Guest





PostPosted: Tue Jan 29, 2008 1:21 pm    Post subject: Sleeves on cable Reply with quote

do not archive

List,
Not to start a flame war, but an old crop duster I knew insisted on two sleeves per end.
In later years, when he discovered heat-shrink tubing, he put two pieces on the cable prior to crimping;
one larger than the other. After the crimp was finished he'd put a short (1/2 inch) piece over the loose end, then slide the smaller diameter of the two up to cover the loose end and apply heat. Then the second, larger diameter tubing, over the first. Beats black tape.

I once asked about the necessity of two sleeves. His rather gruff reply was to the effect that the cable would break before his two sleeves allowed the cable to slip....one less item to worry about while killing bugs amongst trees, power lines, and fences at 100 MPH and three feet off the ground.

He lived to be 85; your results may differ.

Regards to all.

Zed/701/R912/90+%/etc

Winds westerly 18-25, gusts have hit 51 so far in North Texas....probably not a 701 day.


- The Matronics Zenith-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List
Back to top
graeme(at)coletoolcentre.
Guest





PostPosted: Tue Jan 29, 2008 2:17 pm    Post subject: Sleeves on cable Reply with quote

Ref Heatshrink on cable crimps.
Raa has a AD not to use heatshrink on cable crimps there has been corrosion
problems under the heatshrink.
probably caused by retension of moistuer on the cable one Drifter had
considerable corrosion
all cables were to be checked and heat shrink removed

Graemecns
---


- The Matronics Zenith-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Zenith-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group