kmraduls(at)pure.net
Guest
|
 Posted: Sun Mar 16, 2008 5:22 am Post subject: RV7-List Digest: 1 Msgs - 03/15/08 |
 |
|
| Quote: |
================================================
EMail Version of Today's List Digest Archive
================================================
----------------------------------------------------------
RV7-List Digest Archive
---
Total Messages Posted Sat 03/15/08: 1
----------------------------------------------------------
Today's Message Index:
----------------------
1. 09:39 AM - Re: Cowl to Spinner Fit with 2.25 Spacer (Ralph
|
| Quote: | Subject: Re: Cowl to Spinner Fit with 2.25 Spacer
|
This is what worked well for me on my RV6. I cut out 2 semi-cicle filler
rings out of sheets of 3/8 " scotchs pad and satuarated with resin and then
bonded to the foward cowling lip. Then glassed over and filled. Looks
factory. This was needed not because a prop extension but using an
Eggenfellner powerplant in a RV7 cowl. There engine mount has since been
adjusted in length to iliminate the need to do this.
Kelly Landrum
2.5 S/C Sub 155 hr.
RV6
| | - The Matronics RV7-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV7-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
