Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Jabiru 2200 Air Ducts

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Zenith-List
View previous topic :: View next topic  
Author Message
georgerace



Joined: 25 Oct 2006
Posts: 788
Location: Albion, MI

PostPosted: Sat Apr 26, 2008 3:14 pm    Post subject: Jabiru 2200 Air Ducts Reply with quote

I am at the point where I am ready to install the fiberglass air ducts supplied by Jabiru USA in my FWF kit.
Has anyone out there done this?

In reading the instructions and information it says that the fixed divider in the duct should fall between the spark plugs. I notice that there is a gap between the heads and wonder if that is where the divider/deflector should be falling. Mine, on both sides, falls between the rear cylinder spark plugs on both sides.

It appears that in this location, I am going to need to remove most of the divider/deflector.

As it was factory installed I am wondering where I am going wrong.

Any suggestions greatly appreciated.

George
CH701 N73EX (Reserved)
[quote][b]


- The Matronics Zenith-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

_________________
Check out my CH-701 project at:
http://www.mykitairplane.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
IFLYSMODEL(at)aol.com
Guest





PostPosted: Sat Apr 26, 2008 3:26 pm    Post subject: Jabiru 2200 Air Ducts Reply with quote

Hey George: I have not done it on a 2200, but on my 3300, I had to make quite a cut on the rear divider to enable the ducts to fit properly. I also had to add (smaller) dividers over each of the other cylinders to get the proper cooling on my 3300 powered 601 HD.
Lynn Nelsen

Need a new ride? Check out the largest site for U.S. used car listings at AOL Autos.
[quote][b]


- The Matronics Zenith-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Zenith-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group