Matronics Email Lists :: View topic - Flap setting

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Flap setting - equal angle for both flaps.

Matronics Email Lists Forum Index -> Zenith-List

View previous topic :: View next topic

Author Message

psm(at)att.net
Guest

Posted: Mon Apr 28, 2008 2:14 am Post subject: Flap setting - equal angle for both flaps.

Hi Steve,



 I have not yet mounted my wings, but I have thought of the problem of getting the flaps at the same level.  The answer I found is to wait to drill the torque tubes and control arm weldment until the flaps and wings are mounted.  Then when you drill the parts to fix the relative setting for each flap you can tape or otherwise hold the flaps in place so they come out the same.



 Paul

 XL fuselage



 

 At 11:08 AM 4/27/2008, you wrote:



 [quote]I know this builder who has checked his flap settings and one flap is not quite the same as the other...it doesnt raise as high as the other..  Its off  by about 2 degrees.....

 "If" I were to talk to him about adjusting them to have each exactly the same,  what would I say ??

  

 Steve ( name withheld by REQUEST )

  [b]

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

notsew_evets(at)frontiern
Guest

Posted: Mon Apr 28, 2008 5:16 am Post subject: Flap setting - equal angle for both flaps.

Right on Paul.     I just  brought this up because my holes were drilled at the factory.   QBK  you know.....

  

 SW

 [quote]   ---

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Zenith-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum