Matronics Email Lists :: View topic - hangar, unvented heater

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

hangar, unvented heater

Matronics Email Lists Forum Index -> Kitfox-List

View previous topic :: View next topic

Author Message

icubob(at)newnorth.net
Guest

Posted: Sat May 10, 2008 8:59 am Post subject: hangar, unvented heater

good question dwight.

  i do monitor the humidity and it does get  higher. i have a few small leaks so that my vented heater drafts fresh air into  the room from just the vented heater's pilot. the humidity also gets pulled back  down whenever i work because the vented heater is operating. as you know a room  heated with forced air will get dryer than dust and i live in n. wis where the  temp usually below zero and i am building a wooden airplane. i have heard of  warping that occurs in the summer to plywood panels glued in the winter with no  humidity. i have not had any gluing problems.

  

  so there is more humidity but i watch it and  can manipulate it and it seems to be a satisfactory environment.

        bob  noffs

    [quote][b]

- The Matronics Kitfox-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kitfox-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Kitfox-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum