naumuk(at)alltel.net Guest
|
Posted: Thu Aug 14, 2008 3:20 pm Post subject: Mid top pucker |
|
|
All-
This is what I wound up with. It might look a little prettier if I lapped the side skin over the mid top, but this follows plans.
All I did was put the side skin on over top of the mid and work aft to front pushing out the "Bubble", then swapped over/under. I still haven't doubled up on the rivets, so it might wind up looking better.
Optical illusion in the area between the front hoop and the longeron- no distortion there, or at least there won't be after riveting. What looks like garfs in the left side of the picture are duct tape adhesive marks.
do not archive
Bill
| - The Matronics Zenith-List Email Forum - | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
Description: |
|
Filesize: |
36.31 KB |
Viewed: |
175 Time(s) |
|
|
|