ed(at)solairecanada.com Guest
|
Posted: Sat Sep 13, 2008 10:43 am Post subject: RV6-List Digest: 0 Msgs - 09/12/08 |
|
|
I have trimmed my tip-up canopy to the point where it should fit.
The problem is that it still sits about 3/8" above the roll-bar (F631)but
the bend (sag)in the rear top of the canopy already touches F-632A.
I will attach a sketch.
All the measurements and spaces are correct.
1. Can the canopy material be heated to flatten out a bit?
2. Should I drop F-632A (glecoed at this stage)?
Any suggestions out there?
Ed Hollestelle.
--
| - The Matronics RV6-List Email Forum - | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV6-List |
|
Description: |
|
Filesize: |
39.24 KB |
Viewed: |
355 Time(s) |
![RV-6_canopy4.jpg](files/thumbs/t_RV-6_canopy4_872.jpg)
|
|
|