Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Riveter heads

Matronics Email Lists Forum Index -> Zenith-List

View previous topic :: View next topic

Author Message

naumuk(at)alltel.net
Guest

Posted: Wed Dec 31, 2008 5:23 pm Post subject: Riveter heads

All-

     1. The Zenith hand riveter won't  last forever- mine died 30% of the way into my project.

     2. I spent about $10 on two ball  mills (For A4s and A5s) from McMaster Carr and use them to rough out the  profile, then clean off the rough edges with a ball bit in a Dremel. Worked for  me.

     3. If you're going to use both a  hand riveter and pneumatic, make sure the heads are interchangeable- saves lots  of time.

                                                  do  not archive

 Bill Naumuk

Townville, Pa.

HDS 601MG/Corvair  95%

   [quote][b]

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Zenith-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum