Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Routing Elevator Trim Tab Servo Wires

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV8-List
View previous topic :: View next topic  
Author Message
gareywittich2000(at)yahoo
Guest





PostPosted: Sat Jan 24, 2009 10:02 pm    Post subject: Routing Elevator Trim Tab Servo Wires Reply with quote

Greetings:

Looking for a better solution than routing the Trim Tab Servo wires thru the hole in the Elevator Spar (where the long Servo Motor Screw goes).

Does anybody have any pictures or diagrams of the Wire Routing of the Trim Tab Motor wires in the Elevator to the Horizontal STABILIZER to the fuselage.

Not much given on this subject on Matronics.

Thanks, Garey Santa Monica, CA


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List
Back to top
Matt Dralle
Site Admin


Joined: 08 Nov 2005
Posts: 25781
Location: Livermore CA USA

PostPosted: Sat Jan 24, 2009 11:10 pm    Post subject: Routing Elevator Trim Tab Servo Wires Reply with quote

At 10:01 PM 1/24/2009 Saturday, you wrote:
Quote:


Greetings:

Looking for a better solution than routing the Trim Tab Servo wires thru the hole in the Elevator Spar (where the long Servo Motor Screw goes).

Does anybody have any pictures or diagrams of the Wire Routing of the Trim Tab Motor wires in the Elevator to the Horizontal STABILIZER to the fuselage.

Not much given on this subject on Matronics.

Thanks, Garey Santa Monica, CA

Hi Garey,

I just did this task. I simply drilled a 1/4" hole above the servo screw hole and added a little black plastic bushing. Attached is a picture.

Best regards,

Matt Dralle
RV-8 #82880 N998RV (res)
Building Time Since July 2008: 728.75 Hours


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List



Pitch_Trim_Servo_Wire_Hole.jpg
 Description:
 Filesize:  150.47 KB
 Viewed:  239 Time(s)

Pitch_Trim_Servo_Wire_Hole.jpg



_________________
Matt Dralle
Matronics Email List Administrator
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV8-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group