Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

diode on a starter

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Kolb-List
View previous topic :: View next topic  
Author Message
by0ung(at)brigham.net
Guest





PostPosted: Sun Feb 08, 2009 11:33 pm    Post subject: diode on a starter Reply with quote

Quote:
You mentioned the need for a diode on the starter solenoid to prevent
voltage spikes, what specification of diode is used and how is it wired in?
>>>>>>>>>>>>>>>>.

First I wired my kolb so that when the starter is activated,,,, nothing
else can be on... that way a spike cant do any damage... I do not have a
diode on mine. If anyone wants a quick schematic let me know.

If you want to put on a diode... most any rectifying diodes should work
fine (little black diode about 1/8 inch diameter and just over 1/4 inch
long).... they will have a line that goes around them on one end, if the
end with the line is toward the negative terminal they will conduct. So the
secret is to put the end with the line on it on the positive terminal and
the other end on the negative terminal of the starter solenoid coil... that
way when the power is applied there will be no flow through the diode....
but when the circuit breaks ( you let go of the starter switch) the energy
stored in the electrical coils that normally creates a back flow will be
absorbed in the diode.
If you put it in backwards,,, it will blow the diode or the fuse to the
starting circuit.
The final test,,,, for safety and to eliminate shaking so you can see
better, disconnect the wire going to the starter,,, and touch a positive
wire to the solenoid coil with the other side attached to the neg, ground.
You should hear it click. When you remove the wire[Boyd] it will click
back and you will see a spark when the wire is removed..... after you
install the diode and do the same test the spark should be much much
smaller. That way you will know it is in correctly and working.

Boyd Young
Kolb MKIIIC
Brigham City Ut.


- The Matronics Kolb-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Kolb-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Kolb-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group