Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Am I lucky or what?

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Europa-List
View previous topic :: View next topic  
Author Message
hurstkr(at)redzone.com.au
Guest





PostPosted: Sat Mar 07, 2009 9:14 pm    Post subject: Am I lucky or what? Reply with quote

Yesterday morning I backed my trailer up to the door of the local smash repairer's spray booth, unloaded the complete aircraft on its trolleys straight into the booth, closed the doors, dialled up 50 degrees C on the control and turned on the heat. It took a whole 10 min. At 2:00 am this morning, I turned the heat off after 16 hours and at a more respectable hour later this morning, I winched the lot back into the trailer and drove off.

I reckon I'm fortunate !!

In the next few weeks, I'll be going back to start ny next learning experience . . . . painting !!

Ok, I know this is old hat for a lot of you blokes, but I've been looking forward to this moment for a long time. Too long in fact !!

Kingsley from Oz.

do not archive


- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List



DSC03429_(Large).JPG
 Description:
 Filesize:  110.75 KB
 Viewed:  2072 Time(s)

DSC03429_(Large).JPG



DSC03431_(Large).JPG
 Description:
 Filesize:  80.82 KB
 Viewed:  2072 Time(s)

DSC03431_(Large).JPG


Back to top
s(at)vestuti.orangehome.c
Guest





PostPosted: Sun Mar 08, 2009 1:59 pm    Post subject: Am I lucky or what? Reply with quote

Hello Kingsley,
what have you done on the fuselage where it is met
by the Wing Root, is it an optical illusion or have you moulded an extrusion to meet the wing root?

Steve #573
Visit - www.EuropaOwners.org


- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
rlborger(at)mac.com
Guest





PostPosted: Sun Mar 08, 2009 2:18 pm    Post subject: Am I lucky or what? Reply with quote

KIngsley,

You are getting serious here! If you aren't careful, you'll be flying that thing.
Looking Good,
Bob Borger
Europa Kit #A221 N914XL, XS Mono, Intercooled 914, Airmaster C/S
http://www.europaowners.org/N914XL
Aircraft Flying!
3705 Lynchburg Dr.
Corinth, TX 76208
Home: 940-497-2123
Cel: 817-992-1117



On Mar 7, 2009, at 22:51, Kingsley Hurst wrote:
Quote:
Yesterday morning I backed my trailer up to the door of the local smash repairer's spray booth, unloaded the complete aircraft on its trolleys straight into the booth, closed the doors, dialled up 50 degrees C on the control and turned on the heat. It took a whole 10 min. At 2:00 am this morning, I turned the heat off after 16 hours and at a more respectable hour later this morning, I winched the lot back into the trailer and drove off.

I reckon I'm fortunate !!

In the next few weeks, I'll be going back to start ny next learning experience . . . . painting !!

Ok, I know this is old hat for a lot of you blokes, but I've been looking forward to this moment for a long time. Too long in fact !!

Kingsley from Oz.

do not archive<DSC03429 (Large).JPG><DSC03431 (Large).JPG>



- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
hurstkr(at)redzone.com.au
Guest





PostPosted: Mon Mar 09, 2009 4:20 am    Post subject: Am I lucky or what? Reply with quote

Bob Borger said

> You are getting serious here! If you aren't careful, you'll be flying that thing.

How I hope you are correct Bob !

Thanks for the encouragement .

Kingsley

do not archive
[quote][b]


- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List
Back to top
hurstkr(at)redzone.com.au
Guest





PostPosted: Mon Mar 09, 2009 4:20 am    Post subject: Am I lucky or what? Reply with quote

Quote:
what have you done on the fuselage where it is met
by the Wing Root, is it an optical illusion or have you moulded an
extrusion to meet the wing root?

Hello Steve,

I firstly laid up my upper and lower fairings from the fuselage to the wings
bonding the two together.

I then cut the lay-ups with a hacksaw blade so that half of a fairing was
left on the fuse and the other half on the wing. Then sanded the gaps so
that the upper gap was almost 3 mm and the under surface gap almost 2 mm.
These lay-ups were made over blue foam so I then laid up the inside parts of
the foam and after that, the two semi mating surfaces.

The end result is a gap of 2 mm on top and 1 mm underneath. I intend to put
Door and Window Weather Strip on one of the mating surfaces. Only testing
will tell but I hope this should suffice as a seal for local flying. If I
want a perfect seal for X country flying, I will do the old glider trick of
running some PVC tape right around from trailing edge to trailing edge.
Maybe, I will have to use the tape all the time, don't know yet.

Have attached some photos which should explain better than the words above.
The dates on these photos are embarrassing.

Note that the gaps you see in these photos are a little wider than the
finished product because all the glass surfaces have now been filled for
painting which is my next job.

Best regards
Kingsley


- The Matronics Europa-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Europa-List



Upper_Port_from_rear_quarter.jpg
 Description:
 Filesize:  27.15 KB
 Viewed:  2066 Time(s)

Upper_Port_from_rear_quarter.jpg



Door_Strip_1.JPG
 Description:
 Filesize:  102.71 KB
 Viewed:  2066 Time(s)

Door_Strip_1.JPG



Door_Strip_2.JPG
 Description:
 Filesize:  56.98 KB
 Viewed:  2066 Time(s)

Door_Strip_2.JPG



Fairing_Foam_from_front.jpg
 Description:
 Filesize:  22.05 KB
 Viewed:  2066 Time(s)

Fairing_Foam_from_front.jpg



Fairing_Foam_from_rear.jpg
 Description:
 Filesize:  25.07 KB
 Viewed:  2066 Time(s)

Fairing_Foam_from_rear.jpg



Port_flap_down.jpg
 Description:
 Filesize:  34.55 KB
 Viewed:  2066 Time(s)

Port_flap_down.jpg



Port_Upper.jpg
 Description:
 Filesize:  29.1 KB
 Viewed:  2066 Time(s)

Port_Upper.jpg



Rear_Under_surface.jpg
 Description:
 Filesize:  24.92 KB
 Viewed:  2066 Time(s)

Rear_Under_surface.jpg



Shows_part_of_mating_surface.jpg
 Description:
 Filesize:  64.87 KB
 Viewed:  2066 Time(s)

Shows_part_of_mating_surface.jpg


Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Europa-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group