Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

WW intake dimension

Matronics Email Lists Forum Index -> Zenith-List

View previous topic :: View next topic

Author Message

airvair601(at)yahoo.com
Guest

Posted: Sun May 10, 2009 11:43 am Post subject: WW intake dimension

We are building a 601 with a corvair and a MA3 carb. We have made the most of the parts to WW design and are trying to make our own intake (because we like to make stuff), but would like to leave open the possibility of buying the airbox kit.  I am hoping to get the demsion from the lower case bolts where the manifold is attached and the flange that the carb attaches to.  If we have this demension correct, the other parts should fit.  Can anyone provide this demension from the center of the bolt hole on the rear case  to the lower face of the carb flange.  Thanks. phill  and Steve  airvair601 at yahoo.com



ps. this week we built the flanges that attach the intake pipes to the head using the langfords design ( no photos as I can't figure how to post them)



           [quote][b]

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Zenith-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum