rparigor(at)suffolk.lib.n
Guest
|
 Posted: Mon Jul 13, 2009 2:54 pm Post subject: Recovery from unusual nose high attitude |
 |
|
For those of you who have taken for granted you have a good bond between top and bottom fuse seam because you:
**Saw a good squeeze come out of top and bottom of fuse seam during bond
**Inspected with bright lights from inside out, then outside in
**Inspected with a quarter tap
Good bond may not be the case!
In event you found voids and drilled holes and filled with Redux or Redux/flox after the initial bond cured, be aware that although it may make you feel a little better, there is essential no strength gained from this exercise! Unless you scuff sand, or inject while adhesive is uncured, only gain of perhaps 5 or 10% strength. It will however remove air that if left trapped could cause more delamination when in a lower pressure environment. See link below for test.
Humbled once again, but more important recovered from unusual nose high attitude.
http://www.europaowners.org/modules.php?set_albumName=album291&op=modload&name=gallery&file=index&include=view_album.php
Thanks Bud for taking my call and helping come up with a quick resolve.
Ron Parigoris
Bonding on top pictures #66 on:
http://www.europaowners.org/modules.php?set_albumName=album257&op=modload&name=gallery&file=index&include=view_album.php&page
Visit - www.EuropaOwners.org
| | - The Matronics Europa-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Europa-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
