Matt Dralle
Site Admin
Joined: 08 Nov 2005
Posts: 25203
Location: Livermore CA USA
|
 Posted: Thu Jul 16, 2009 4:49 pm Post subject: Grove Gear On RV-8 - Taller Than Stock? |
 |
|
Dear Listers,
There was an RV-8 parked out on the ramp at Livermore a couple of weeks ago and so I went over and checked it out. Can't remember the N number now, but it appeared to be an older one. It had the stock landing gear with the fiberglass airfoiled covers over the square legs.
But what I seemed to notice is that it sat lower on the gear. So, I measured from the ground to the top-side rivet at the firewall. I went home and made the same measurement on my RV-8 with the airfoiled gear and measured a full 6" taller at that point. I really like the taller look, but I'm wondering why its so much taller? I don't have the engine on yet, but I can't imagine it was sag that much with engine on. If I pull on the engine mount with my 6'1" and 240 lbs it doesn't move much at all.
Anyone else notice this phenomenon?
Matt Dralle
RV-8 #82880 N998RV
Pulling The Wings Back Off To Finish Fairings...
| | - The Matronics RV-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV-List |
|
| Description: |
|
| Filesize: |
150.12 KB |
| Viewed: |
1712 Time(s) |
|
| Description: |
|
| Filesize: |
168.46 KB |
| Viewed: |
1712 Time(s) |
|
_________________
Matt Dralle
Matronics Email List Administrator |
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
