Matronics Email Lists :: View topic - Conduit Placement in QB RV7 Wings

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Conduit Placement in QB RV7 Wings

Matronics Email Lists Forum Index -> RV9-List

View previous topic :: View next topic

Author Message

Bill Schlatterer

Joined: 09 Jan 2006
Posts: 195

Posted: Sat Jul 25, 2009 5:17 pm Post subject: Conduit Placement in QB RV7 Wings

Can't decide if this is a good thing to do or not.  I need to run conduit in my QB wings but there are no consistent tooling holes anywhere except where Vans put the pitot holes and the one tooling hole above that.  (actually below if the wing is right side up).     

It would be pretty easy to put a 3/4 hole in place of the pitot holes and in the tooling holes above with a 3/4 step drill and a 4 foot extension but it would get pretty close to the spar.  Is there an edge distance issue with this or does it even apply?  Doing it anywhere else without the tooling holes is problematic?  

Any comments, suggestions, pictures appreciated. <<...>>   

  

Bill S  

RV7 only the wings left,….

- The Matronics RV9-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV9-List

Nikon_20090725_281.JPG

Description:

Filesize:

68.87 KB

Viewed:

2877 Time(s)

Display posts from previous:

	Matronics Email Lists Forum Index -> RV9-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum