rgf(at)dcn.davis.ca.us
Guest
|
 Posted: Sun Jul 26, 2009 9:12 am Post subject: RV-List: Conduit Placement in QB RV7 Wings |
 |
|
I did something similar, but with these hangars from Terminal Town:
http://www.terminaltown.com/Pages/Page65.html
http://tinyurl.com/noxv5z
Ralph Finch
From: owner-rv9-list-server(at)matronics.com [mailto:owner-rv9-list-server(at)matronics.com] On Behalf Of John Morgensen
Sent: Saturday, July 25, 2009 10:37 PM
To: rv-list(at)matronics.com
Subject: Re: RV-List: Conduit Placement in QB RV7 Wings
Bill Schlatterer wrote:
Can't decide if this is a good thing to do or not. I need to run conduit in my QB wings but there are no consistent tooling holes anywhere except where Vans put the pitot holes and the one tooling hole above that. (actually below if the wing is right side up).
It would be pretty easy to put a 3/4 hole in place of the pitot holes and in the tooling holes above with a 3/4 step drill and a 4 foot extension but it would get pretty close to the spar. Is there an edge distance issue with this or does it even apply? Doing it anywhere else without the tooling holes is problematic?
Any comments, suggestions, pictures appreciated. <<...>>
Bill S
RV7 only the wings left,….
This is what I did: CPVC? (lighter than regular PVC) and joist hangers from Big R Ranch Supply.
John Morgensen
[img]cid:image001.jpg(at)01CA0DD8.04DB5320[/img]
| | - The Matronics RV9-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV9-List |
|
| Description: |
|
| Filesize: |
65.67 KB |
| Viewed: |
3020 Time(s) |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
