jj(at)sdf.lonestar.org
Guest
|
 Posted: Wed Sep 02, 2009 6:53 pm Post subject: Another power distribution scheme |
 |
|
I'm building a VFR Murphy Rebel with an electronic ignition Subaru
engine and dual rear mounted batteries. I've been working on a power
distribution plan for a couple weeks and I think I got it where I'm
happy with it but wanted to maybe get some input from you folks. You
know - get a few knowledgeable eyes on it and make sure I'm not doing
something really stupid.
Couple notable items,
I am using an internally regulated alternator - I chose not to have an
alternator disconnect. I figure the risk of damaging the alternator or
avionics through load dump was just too great. The B lead goes straight
to battery A. I did however provide a solution for the remote chance of
an OV fault by isolating battery A and running off battery B. Battery A
is sacrificed in this case.
The essential bus can be fed from either or both batteries. The
non-essential bus drops out during battery only operation - this can be
overridden for preflights etc.
I know I could just copy one of the Z drawings and they were a huge
knowledge boost to study but none seemed to fit exactly what I had in
mind and I get a lot of satisfaction going through the noodling process.
Thanks for looking,
Joel
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
| Description: |
|
Download |
| Filename: |
power_distribution.pdf |
| Filesize: |
138.52 KB |
| Downloaded: |
134 Time(s) |
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
