 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
leinad
Joined: 19 Sep 2006
Posts: 283
Location: Central Virginia
|
 Posted: Sun Sep 27, 2009 4:18 pm Post subject: nut plates / anchor nuts |
 |
|
I'm looking for a less expensive source for these. I've got a lot more access covers to install and I was very disappointed to see the price on the ones I like has gone up greatly at ACS. They are now almost 2 dollars a piece! I think the last time I purchased them they were around 20 cents a piece.
The ones I've been using are K1100-06. They are the "dimpled ones for receiving flat head screws.
Dan Dempsey
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
_________________
Scratch building XL with Corvair Engine |
|
| Back to top |
|
 |
rene(at)felker.com
Guest
|
| Posted: Sun Sep 27, 2009 4:45 pm Post subject: nut plates / anchor nuts |
|
|
58 cents at piece at Vans....
Rene'
801-721-6080
--
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
| Back to top |
|
|
leinad
Joined: 19 Sep 2006
Posts: 283
Location: Central Virginia
|
| Posted: Wed Sep 30, 2009 5:28 pm Post subject: Re: nut plates / anchor nuts |
|
|
Ordered them from Van's last night. They shipped them today. They were 80 cents each.
Dan
| leinad wrote: | I'm looking for a less expensive source for these. I've got a lot more access covers to install and I was very disappointed to see the price on the ones I like has gone up greatly at ACS. They are now almost 2 dollars a piece! I think the last time I purchased them they were around 20 cents a piece.
The ones I've been using are K1100-06. They are the "dimpled ones for receiving flat head screws.
Dan Dempsey |
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
_________________
Scratch building XL with Corvair Engine |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
