Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Rudder cable to Rudder attach.

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Lightning-List
View previous topic :: View next topic  
Author Message
info(at)flylightning.net
Guest





PostPosted: Wed Oct 14, 2009 11:14 am    Post subject: Rudder cable to Rudder attach. Reply with quote

To group,

A few months back, maybe several now, there was some discussion about the geometry of the rudder cable to the rudder attach u bracket. I know that the group had come up with a good solution but here is another easy off the shelf solution. Dave up in New York suggested it and this should work very well. Replace you U bracket with a male rod-end. The hole has a 10-32 plate in the rudder, so a standard 10-32 male rod end will work great. Use a washer and jam nut under the rod-end. The rod end will end up putting the pivot slightly farther forward than the u bracket. It may be necessary to re-adjust your cables, and in extreme cases shorten the threaded portion of the cable slightly to fit properly into the turn-buckle. If you don’t have an issue than don’t worry about it, if you do this can be a very good solution.

Nick


- The Matronics Lightning-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Lightning-List
Back to top
selwyn



Joined: 12 Mar 2008
Posts: 102
Location: Australia

PostPosted: Thu Oct 15, 2009 3:06 am    Post subject: Re: Rudder cable to Rudder attach. Reply with quote

Hi Nick,

That's OK as far as it goes but what do you use to get from the rod end to the cable which has a single tang on the end? A bolt through the rod end and then through the cable end?


- The Matronics Lightning-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Lightning-List

_________________
Cheers, Selwyn
Kit 66 VH-ELZ
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Lightning-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group