Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

TeamGrumman-List Digest: 1 Msgs - 12/14/09

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> TeamGrumman-List
View previous topic :: View next topic  
Author Message
dww0708(at)bellsouth.net
Guest





PostPosted: Tue Dec 15, 2009 12:45 am    Post subject: TeamGrumman-List Digest: 1 Msgs - 12/14/09 Reply with quote

you a serious voltage drop,,,  

--- On Tue, 12/15/09, TeamGrumman-List Digest Server <teamgrumman-list(at)matronics.com> wrote:
Quote:

From: TeamGrumman-List Digest Server <teamgrumman-list(at)matronics.com>
Subject: TeamGrumman-List Digest: 1 Msgs - 12/14/09
To: "TeamGrumman-List Digest List" <teamgrumman-list-digest(at)matronics.com>
Date: Tuesday, December 15, 2009, 1:59 AM

*

=========================
Online Versions of Today's List Digest Archive
=========================

Today's complete TeamGrumman-List Digest can also be found in either of the
two Web Links listed below.  The .html file includes the Digest formatted
in HTML for viewing with a web browser and features Hyperlinked Indexes
and Message Navigation. The .txt file includes the plain ASCII version
of the TeamGrumman-List Digest and can be viewed with a generic text editor
such as Notepad or with a web browser.

HTML Version:

http://www.matronics.com/digest/digestview.php?Style=82701&View=html&Chapter=2009-12-14&Archive=TeamGrumman

Text Version:

http://www.matronics.com/digest/digestview.php?Style=82701&View=txt&Chapter=2009-12-14&Archive=TeamGrumman
=======================
EMail Version of Today's List Digest Archive
=======================
  ----------------------------------------------------------
  TeamGrumman-List Digest Archive
  ---
  Total Messages Posted Mon 12/14/09: 1
----------------------------------------------------------
Today's Message Index:
----------------------

 1. 07:28 PM - AG5B wiring question (teamgrumman(at)AOL.COM (teamgrumman(at)AOL.COM))

________________________________ Message 1 _____________________________________
Time: 07:28:30 PM PST US
Subject: AG5B wiring question
From: teamgrumman(at)AOL.COM (teamgrumman(at)AOL.COM)

I've got a 92 AG5B in my hangar for a new engine. While at it, I decided
to clean up the wiring. I hate sloppy wiring. This is one of those AGs
with the grounds on the vacuum filter. Go figure that one. In the past,
I've moved those grounds to the engine mount (the lug on the back). I've
done that to about 6 planes so far. Never had a problem.
While at the FWF restoration, I decided to change the battery & starter re
lays. Funny thing is, I can't get the relays to work. Rather than instal
ling them the way they came from the factory, I mounted them with the cap
down as shown in the 'preferred mounting' diagram that came with the rela
ys. Other than that, and the positive not going to big terminal marked "B
AT" on the battery relay (the diagram doesn't show that it matters, just
need to use the big terminal,) everything is connected the way it came of
f the old relays.
Here is the setup:
(1) No engine or engine mount.
(2) Ground wire attached to the upper right (airframe) engine mount with
an engine mount bolt.
  - then attached to the neg side of the battery. 
(3) Power cable (positive) from battery to battery relay.
(4) Only 5 (or so) volts measured at the other engine mounts.
(5) Connected a separate ground to the bundle of grounds that went to the
vacuum pump and now I get 24 (or so) volts at the other engine mounts.
It's almost as though the grounds in the cabin depend on the ground to th
e vacuum filter.
(6) Still no action on the master (battery) relay.
(7) Ran a jumper from the negative side of the battery to the relay contac
t and the relay energizes . . . except . . . there is only 5 volts on th
e output side of the relay.
I gave up for tonight.
I could really use a wiring diagram for this plane. So far, the current
flow logic isn't making sense. Anyone know what the cannon plug code is?
Back in the old days, I could read the number on the wire and look it up
. All of these wires are covered with expando sleeve.
Help. Anyone.<= (And Get Some AWESOME FREEnbsp; * The Builder's Bookstore onics.com/contribution" target=_blank>http://www.matronics.com/contributi; -Matt Dralle, List Admin= --> http://forums.=====================

[quote][b]


- The Matronics TeamGrumman-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?TeamGrumman-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> TeamGrumman-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group