donaho1(at)verizon.net Guest
|
Posted: Wed Jan 13, 2010 2:42 pm Post subject: Fuel pumps in series |
|
|
Hi All, This is how I know both pumps are working on my FSII. I flip on the
facet while the engine is NOT running. I can hear the pump running and
watch fuel fill the fuel lines running to the carbs, thus verifying that
pump. Then I shut the facet off and start the engine for my warm up this
verifies the diaphragm pump is working. Before I take the active runway I
flip the facet back on for take off and climb out. When I reach my cruising
altitude I flip the facet off again. When I`m ready to land I flip the
facet back on until I shut down the engine at my trailer. In the past I
would let the facet run during the entire flight but my flight instructor
didn`t like that. He felt that if either pump failed in flight, I wouldn`t
be aware of it. I know there are two schools of thought about turning the
facet on and leaving it on and turning it off after climb out. All I can
say is I trust my instructors opinion and do what he advises. Anyway this
procedure works for me. Lanny N398LF
| - The Matronics Kolb-List Email Forum - | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Kolb-List |
|
|
|