Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

tube valve stem nuts

Matronics Email Lists Forum Index -> Zenith-List

View previous topic :: View next topic

Author Message

maarten versteeg

Joined: 15 May 2007
Posts: 37
Location: San Antonio

Posted: Thu Jan 21, 2010 5:42 am Post subject: tube valve stem nuts

Hello All,



I am in the process of assembling the wheels and have a question about

the nuts on the valve stem. I have read the MATCO instructions and put

talcum powder on the tube and I can reassemble the rim. I can route the

stem through the little hole in the rim but there is one washer and two

different nuts on the valve stem. Where do these two nuts go, are they

both used to tie the washer against the rim, or is only a single one used,

how tight should these nuts be tied down (presumably after the tire has

been inflated?



- Maarten, San Antonio, reserved 581SL

plans building 601, but using some of the kits

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

_________________
Maarten Versteeg
601XL scratch building wings

Display posts from previous:

	Matronics Email Lists Forum Index -> Zenith-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum