 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
mtherr(at)yahoo.com
Guest
|
 Posted: Sun Mar 07, 2010 6:54 pm Post subject: Reducing a hole diameter? (alternator pulley) |
 |
|
Thanks guys,
After I wrote my inquiry, I was thinking of a couple of simpler approaches... Anodizing puts .001" of material back... which may make the pulley OK....?
Another tought.. but not sure about that one... Putting a layer of JB weld and back on the lathe to size it properly (should I trust jb weld enough for that purpose? I know I "welded" my fluting tool for the ribs with that at the beginning my my project in 1999 and the pins and plates are still in place (and the tool fell off several times).
If not... I guess I'll just start from another block of aluminum...
----------------------------
Michel Therrien CH601-HD, C-GZGQ
http://mthobby.pcperfect.com/ch601
http://pages.infinit.net/mthobby
__________________________________________________________________
Looking for the perfect gift? Give the gift of Flickr!
http://www.flickr.com/gift/
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
| Back to top |
|
 |
Juan Vega Jr
Joined: 13 Jan 2009
Posts: 157
|
| Posted: Mon Mar 08, 2010 6:09 am Post subject: Reducing a hole diameter? (alternator pulley) |
|
|
send it to a plasma coater, or get a better fitting peice. Dont half ass it.
Juan
--
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
|
|
| Back to top |
|
|
ronlee
Joined: 25 Dec 2006
Posts: 141
|
| Posted: Mon Mar 08, 2010 2:55 pm Post subject: Re: Reducing a hole diameter? (alternator pulley) |
|
|
Consider the consequences if it should fail. After all this isn't going on a garden tractor!
| | - The Matronics Zenith-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith-List |
|
_________________
Ron Lee
Tucson, Arizona |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
