john.marzulli(at)gmail.co
Guest
|
 Posted: Thu Apr 01, 2010 9:38 am Post subject: Has anyone made the cabin floor 7F8-8 and 7F8-7 as 1 piece |
 |
|
Would it be stronger without the join? The area where the two pieces overlap would be 0.041
John Marzulli
http://www.GenevieveMarzulli.org/
http://MarzulliPhoto.net/
http://701Builder.blogspot.com/
On Thu, Apr 1, 2010 at 10:03 AM, ablebob <rastacey(at)nl.rogers.com (rastacey(at)nl.rogers.com)> wrote:
[quote]--> Zenith701801-List message posted by: "ablebob" <rastacey(at)nl.rogers.com (rastacey(at)nl.rogers.com)>
I am at the stage of cutting out the forward fuselage floor 7F8-8 and the rear floor 7F8-7 and was considering cutting one large piece without a join. Except that one is .025 and the other .016 is there any reason these 2 pieces couldn't be cut as 1 part? It would be stronger without the join and the weight penalty less than a few ounces. Not having built a 701 before I was wondering if there is any reason this could not be done. It seems too simple that nobody has done it before??
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=292675#292675
iption,
www.matronics.com/Navigator?Zenith701801-List" target="_blank">http://www.matronics.com/Navigator?Zenith701801-List
ronics.com/" target="_blank">http://forums.matronics.com
Matt Dralle, List Admin.
=====
[b]
| | - The Matronics Zenith701801-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith701801-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
