Sam
Joined: 18 May 2008
Posts: 135
|
 Posted: Wed May 19, 2010 8:41 am Post subject: Issues with getting Lightspeed RPM readout posted to Dynon |
 |
|
I tried to do something similar, with my D180, but with a RWS EC3 EFI & a single mag. It didn't like the combination and so I have just the EFI tied in and that works just fine.
I would strongly suggest you post your message on the Dynon support forum. You get direct answers from the Dynon staff - from the horses' mouth, so to speak.
Sam
On Wed, May 19, 2010 at 10:36 AM, <longg(at)pjm.com (longg(at)pjm.com)> wrote:
[quote]
I have a dual Lightspeed Plasma III ignition and a D180 EFIS on which I would like to display the RPM output supposedly provided by the Lightspeed box.
I’ve wired the L & R pin 6 outputs to the D180 L & R RPM inputs and the Lightspeed pin 13 output to the EFIS ground.
Continuity is good. I have setup the EFIS to meet the output parameters of the Lightspeed. 2 pulses/revs. Signal output is not verified. I do not have a scope to check the pulses.
Not a smirk of activity happening on the EFIS. Engine starts and runs correctly. I have the optional display which provides an RMP readout, albeit on a separate display.
Just wondering if anyone has crossed this bridge yet.
Thanks,
Glenn
| Quote: |
ist" target="_blank">http://www.matronics.com/Navigator?AeroElectric-List
tp://forums.matronics.com
_blank">http://www.matronics.com/contribution
|
[b]
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
_________________
Sam Hoskins
www.samhoskins.blogspot.com |
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
