nuckolls.bob(at)aeroelect
Guest
|
 Posted: Wed Jun 02, 2010 8:40 am Post subject: Speaking of soldering |
 |
|
At 08:10 AM 6/2/2010, you wrote:
| Quote: | Hello Bob,
What was the product you purchased? |
Sorry, here's one of several offerings for the
tool on Ebay.
http://tinyurl.com/278pb3w
Bill makes an important point. This critter is
an ignition hazard so be cognizant of the working
environment. Combustible liquids with low
vapor pressures are especially hazardous. I keep
cans of "carburetor cleaner" (really a kind of lacquer
thinner in a aerosol can) around for little shots
of de-greasing agent. It avoids having spillable
containers of the stuff around and limits the
amount and duration of combustible mix in the air.
Also, you DO want to check for effective shut-off
for gas flow. I've had a few tools over the years
that would leak out in the toolbox . . . but this
is rare. You can charge your new tool and just let
it set for a goodly amount of time and make sure
it's tight. You can perhaps smell gas flows that are
too small to hear.
Bob . . .
[quote][b]
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
