Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CHT temps

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RotaxEngines-List
View previous topic :: View next topic  
Author Message
thilo.kind(at)gmx.net
Guest





PostPosted: Thu Jul 08, 2010 4:59 am    Post subject: CHT temps Reply with quote

Hi folks,

in need for some advice. I'm flying a Zodiac CH 601 HDS with Rotax 912 UL. Engine parameters are monitored with an EIS. CHT temps were always around 100 F plus / minus a bit depending on OAT. Water temps in cruise are 150 F.

Both CHT's were always the same with little to no fluctuation. That seemed a bit strange, so I recently disconnected the wire harness from the EIS and from the CHT and measured the cables. Everything seemed fine and I put it back to together. Now I observing basically the same CHT temps, but they fluctuate quite a bit - within a few seconds they might go up to 125 F and fall right back, etc. Anybody with an idea about the cause?

Thanks

Thilo
--
GRATIS für alle GMX-Mitglieder: Die maxdome Movie-FLAT!
Jetzt freischalten unter http://portal.gmx.net/de/go/maxdome01


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List
Back to top
Roger Lee



Joined: 10 Jan 2006
Posts: 1464
Location: Tucson, Az.

PostPosted: Thu Jul 08, 2010 5:11 am    Post subject: Re: CHT temps Reply with quote

A loose connection will cause this, and seeing that you just removed the wires that would be my guess. The connections on the CHT probe should be snug and not loose to move freely. It should be snug on the probe end. If you are really running 100F then that is too cold. Or did you mean 100C?
What rpm are you cruising at, what are the oil temps and EGT's if you have this info. Typically water temp and CHT's are only a few degree spread, 50F is more than it should be.


- The Matronics RotaxEngines-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RotaxEngines-List

_________________
Roger Lee
Tucson, Az.
Rotax Instructor & Rotax IRC
Light Sport Repairman
Home 520-574-1080 TRY HOME FIRST
Cell 520-349-7056
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RotaxEngines-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group