enginerdy(at)gmail.com
Guest
|
 Posted: Mon Oct 18, 2010 12:06 pm Post subject: Which connection from a Garmin 296 to my Dynon 180? |
 |
|
I spent a lot of time dealing with a similar problem.. In my case, a
496 simply refused to give a serial signal on Data 2! Turns out that
(I believe) only the 296 has TWO data out lines. All the others have
the connector for it, but only one serial out line.
It should be just fine to splice the existing serial wire to several
devices, as long as you don't go crazy. I think I heard the number 5
from either Dynon or Garmin at one point.
It's worth noting that if you upgrade to a different GPS with the same
power/data connector, the Data 2 line will likely not work.
Hope that helps,
--Daniel
On Mon, Oct 18, 2010 at 2:33 PM, Geoff Heap <stol10(at)comcast.net> wrote:
| Quote: |
New question guys. I did in fact wire from the Garmin 296 to the Dynon using the DATA OUT 2(violet) wire.
When I install an ELT it will be the ACK-04 with GPS compatability. I imagine that it will be the same GPS wire (data 2 out (violet)) that I will need to send position data to the ELT. Assuming this is true, can I splice into that wire?........Geoff
--------
Dual controls. Dynon 180. Icom 210 Garmin 296. Becker transponder. Sigtronics intercom. Electric flaperons.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=316231#316231
|
--
Daniel Hooper
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
