Matronics Email Lists :: View topic - 912 water temp probe?

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

912 water temp probe?

Matronics Email Lists Forum Index -> Zenith-List

View previous topic :: View next topic

Author Message

zsmith3rd(at)earthlink.ne
Guest

Posted: Fri May 05, 2006 8:40 am Post subject: 912 water temp probe?

List,



Anyone installed an actual 'water temperature' sender on a 912 in the water circuit?

The two holes provided by Rotax for the CHT on cylinders 2 & 3 don't actually touch water.

 

Any advice from experienced 912 jocks?  



Thanks!



Regards to all,



Zed/701/R912/90+%/etc/do not archive

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

cgalley(at)qcbc.org
Guest

Posted: Fri May 05, 2006 1:13 pm Post subject: 912 water temp probe?

The fact that there are not thru holes will not influence the temperature by 

much if any.  The big thing is that they won't leak when the probe fails. 

Nor will the coolant corrode the probe.



Cy Galley - Chair,

AirVenture Emergency Aircraft Repair

A Service Project of Chapter 75

EAA Safety Programs Editor - TC

EAA Sport Pilot

---

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

thilo.kind(at)gmx.net
Guest

Posted: Fri May 05, 2006 1:48 pm Post subject: 912 water temp probe?

Hi Zed,



 I have installed a water temp probe. In my CH601 HDS, I'm using an original

Rotax rad inside the cowling. Most of the plumbing is made from rubber

hoses, but one section is 2'' AL piping. On this section I had a small tube

welded on, at which end the probe is installed. Working okay so far (since 4

years). However, it's not really needed, since the CHT probes are

sufficient.



Best regards



Thilo Kind

---

- The Matronics Zenith-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Zenith-List

Display posts from previous:

	Matronics Email Lists Forum Index -> Zenith-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum