Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Need wheel pant part numbers!!! Need new nosewheel pant

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV10-List
View previous topic :: View next topic  
Author Message
Tim Olson



Joined: 25 Jan 2007
Posts: 2872

PostPosted: Sun Feb 27, 2011 7:38 pm    Post subject: Need wheel pant part numbers!!! Need new nosewheel pant Reply with quote

U-1013A Front
U-1013B Rear

Tim Olson - RV-10 N104CD
do not archive
On 2/27/2011 8:42 PM, Eric_Kallio wrote:
Quote:


I left my plans at the hanger and I need to order both halves of a front wheel fairing for my -10. Search of the webstore pointed me to the RV-12 gear. Here is why I need a new fairing.

While on short final for the first of what was to be a couple of touch and goes during my fly-off I heard a bit of a buzzing out front. Nothing serious I thought since there was a bit of a cross wind I figured it was the nose wheel coming straight as I got below the trees and out of the crosswind. I touched down on the mains and started the flaps up, added power and picked right back up. At about 50 feet I heard a pop. That is when a friend in another aircraft waiting to take off called me on the radio asking if I planned to come back around and pick up the pieces of my nose wheel pant from the runway. According to him and another witness on the ground, when I first approached it looked like the left side of the wheel pant was fluttering as if it had pulled through the screws.When I hit the power for the go-around and picked up speed it "exploded"(their words) into about 8 major pieces. Post-mortem of the wheel pant supports the ground reports of potential pulled through m

ou!
Quote:
nting screws. The left screw holes are enlarged while the right ones held and I pulled some smaller pieces from under these screws. I will be redoing the wheel pant of course. Except this time I will be adding more glass to the sides and spreading the load with tinnerman washers at a minimum.

Eric Kallio
N518RV 16 hours of phase 1 remaining.


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=332252#332252




- The Matronics RV10-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV10-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group