larry(at)macsmachine.com
Guest
|
 Posted: Mon Apr 11, 2011 5:07 am Post subject: [Probable Spam] Oil door latch installation procedure? |
 |
|
Hi John,
The dzus stud is retained by a plastic washer. The washer captures the reduced neck and can be bought or made from milk jug material.
See link, http://www.macsmachine.com/images/cowling/full/Dzustools.gif
My cowling page shows an oil door with Dzus and hinge components.
Larry McFarland 601HDS at www.macsmachine.com
From: owner-zenith701801-list-server(at)matronics.com [mailto:owner-zenith701801-list-server(at)matronics.com] On Behalf Of John Marzulli
Sent: Sunday, April 10, 2011 11:53 PM
To: zenith701801-list(at)matronics.com
Subject: [Probable Spam] Oil door latch installation procedure?
I can't figure out how to install the Dzus fastener for my oil door.
The Zenith manual skips over this step.
My guess is to match drill a large hole to fit the wing nut part and then rivet the "S" shaped piece underneath on the door frame.
The question then becomes how the wing-nut part is retained when the door is opened. It seems like the fastener would just fall out with an open door.
Thanks,
John Marzulli
http://MarzulliPhoto.net/
http://701Builder.blogspot.com/ | Quote: | | http://www.matronics.com/Navigator?Zenith701801-List |
01234567
[quote][b]
| | - The Matronics Zenith701801-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith701801-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
