Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Initial experience with dual Odyssey PC680s powering RV-1

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> AeroElectric-List
View previous topic :: View next topic  
Author Message
nuckolls.bob(at)aeroelect
Guest





PostPosted: Sun Sep 04, 2011 1:56 pm    Post subject: Initial experience with dual Odyssey PC680s powering RV-1 Reply with quote

At 03:28 PM 9/4/2011, you wrote:
Quote:
--> AeroElectric-List message posted by: "Richard E. Tasker" <retasker(at)optonline.net>

Have you measured the voltage at the starter and an adjacent ground point and compared it to the same measurement at the battery terminals, both while cranking?

Possibly you have a bad or loose connection somewhere that is contributing to your hard cranking.

Certainly worth a try (if you haven't already done this) to avoid replacing the battery and battery holder.

Dick Tasker

Absolutely. These batteries have a DEMONSTRATED ability
to do the job for which you've installed them. You need
DATA on where energy from the batteries is being lost
before it reaches the starter motor.

Unfortunately, the current draw of a starter motor
is so wiggly, it's difficult to get meaningful measurements
on a starter while standing behind a swinging prop. Suggest
you acquire the use of a battery load tester like this
Harbor Freight product
[img]cid:.0[/img]

Unhook the starter feed wire at the starter and put
a bolt through the lug end with a nut to get a good
grip. Clip the red test lead to the bolt (you don't
want an imperfect connection to burn your lug).
Similarly, fabricate a short piece of 4AWG with
a lug-bolt assembly on one end and a lug on the
other suitable for grounding to your engine . . .
preferably the same bolt that attaches the starter.

The voltmeter on this tester reads voltage
right at the test clips . . . so you don't need
to worry about votlage drop in the long fat-wires.
Simulate an engine cranking event while cranking
the load tester up to 200A . . . you should have
9V+

Use the same tester to load each battery until
the voltage drops to 9V. Each battery should
be capable of delivering 9V at 400 amps or more.



Bob . . .


- The Matronics AeroElectric-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?AeroElectric-List



4c6d6e.jpg
 Description:
 Filesize:  14.39 KB
 Viewed:  650 Time(s)

4c6d6e.jpg


Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> AeroElectric-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group