Matronics Email Lists :: View topic

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Power Flow cutout

Matronics Email Lists Forum Index -> TeamGrumman-List

View previous topic :: View next topic

Author Message

teamgrumman(at)yahoo.com
Guest

Posted: Sun Sep 18, 2011 7:06 pm Post subject: Power Flow cutout

When I install a Power Flow Exhaust System, I cut out the exit ramp so the pipe can slip out through the opening.  The template I use is actually one of the cutouts from a Jaguar cowling.  I scanned it (yes, I out the fiberglass on the scanner flatbed) and now have a drawing.  Unfortunately, when printed out, it's about 3/4 inches too short.  The width is the same as the scan, it's just shorter.  I haven't measured it, but, the width where the muffler slips in is about 1/4 inches bigger than the muffler.  When installed, it provides about 1/2 inches clearance all around.  

If you can use it, great.  If not, no worries.

- The Matronics TeamGrumman-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?TeamGrumman-List

Power_Flow_Cutout.jpeg

Description:

Filesize:

25.11 KB

Viewed:

439 Time(s)

Display posts from previous:

	Matronics Email Lists Forum Index -> TeamGrumman-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum