carlossa52(at)gmail.com
Guest
|
 Posted: Sun Jun 10, 2012 3:18 pm Post subject: upper bearing |
 |
|
Hello, allI am working on the (CH601-HD) firewall, and I am doing some changes based on the XL and the 750 firewall. The addition of the plastic upper bearing is causing me a bit of concern.In my case, the bearing interferes with rivets placed through 6F10-2 (the original CH601-HD upper bearing) and 6F8-2 (firewall stiffener). These parts can be sen on page 11 of this document: http://www.zenithair.com/pdf-doc/601-firewall-gear-rib.pdf I am using UHDMW (or some such mix of letters) 3/8" thick.I cut notches to clear the rivets. What is bugging me is that I could not find any comments about this interference, so maybe I am doing something incredibly wrong (I am not content with doing anything just "credibly" wrong). My "notched" upper bearing can be seen here: http://www.flickr.com/photos/54366879(at)N06/7359287022/ These notches might be weakening the part to a point where it will easily brake and be ineffective, reason why I am planning on a duplicate (no notches) installed on top of it.
Comments, anyone?Carlos CH601-HDhttp://www.zenith.aero/photo/img-6037
[quote][b]
| | - The Matronics Zenith750-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Zenith750-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
