Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Battery Installation and Wire Routing Provisions

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV8-List
View previous topic :: View next topic  
Author Message
graybeard



Joined: 20 Sep 2011
Posts: 33
Location: Grants Pass, OR

PostPosted: Sat Aug 25, 2012 1:54 pm    Post subject: Battery Installation and Wire Routing Provisions Reply with quote

I’m looking for feedback on adding wire routing holes to F-806B and F-807A. Specifically, I could use an additional set on the right side so that I can route the transponder antenna cable under the floor. I have the one set, matching the left side battery cable routing holes, which I intend to use for ADAHRS and A/P pitch servo cable wire routing. I’m planning 1 ea. 5/8” dia. hole in F-806B at 2.5” outboard of the rudder cable hole and just outboard of the F-813R-1 Seat Rib in F-807. Van’s has no comment. Guess the builder mod’s here have been too many and varied to analyze each one. I’m more than willing to go on past experience.

Also question re battery installation. I’m going with an O-360 and 3-bladed Catto prop, so I think a forward battery makes sense. Was looking at the lower right side of the baggage compartment, but that looks next to impossible in a QB. Has anyone else done that?

Thanks in advance for any and all comments.

Stan Loer
RV-8 QB
stazel(at)cpros.com

[quote][b]


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List
Back to top
View user's profile Send private message
Matt Dralle
Site Admin


Joined: 08 Nov 2005
Posts: 25627
Location: Livermore CA USA

PostPosted: Sat Aug 25, 2012 4:14 pm    Post subject: Battery Installation and Wire Routing Provisions Reply with quote

At 02:53 PM 8/25/2012 Saturday, you wrote:
Quote:
I’m looking for feedback on adding wire routing holes to F-806B and F-807A. Specifically, I could use an additional set on the right side so that I can route the transponder antenna cable under the floor. I have the one set, matching the left side battery cable routing holes, which I intend to use for ADAHRS and A/P pitch servo cable wire routing. I’m planning 1 ea. 5/8” dia. hole in F-806B at 2.5” outboard of the rudder cable hole and just outboard of the F-813R-1 Seat Rib in F-807. Van’s has no comment. Guess the builder mod’s here have been too many and varied to analyze each one. I’m more than willing to go on past experience.

Also question re battery installation. I’m going with an O-360 and 3-bladed Catto prop, so I think a forward battery makes sense. Was looking at the lower right side of the baggage compartment, but that looks next to impossible in a QB. Has anyone else done that?

Thanks in advance for any and all comments.

Stan Loer
RV-8 QB
stazel(at)cpros.com

Hi Stan,

The RV-8 is really setup nice for a rear battery installation. Works out very nicely. My RV-8, while it does have a Hartzell CS prop, its REALLY nose heavy, especially flying solo. If you're going with an IO360, I think you're still going to be fine with a rear mounted battery even if you go with a lighter Catto prop. I wish I could put TWO batteries back there... Wink

Matt


-
Matt Dralle

RV-8 #82880 N998RV "Ruby Vixen"
http://www.mattsrv8.com - Matt's Complete RV-8 Construction Log
http://www.mattsrv8.com/Mishap - Landing Mishap Rebuild Log
http://www.youtube.com/MattsRV8 - Matt's RV-8 HDTV YouTube Channel
Status: 172+ Hours TTSN - Rebuilding Fuselage After Landing Mishap...

RV-6 #20916 N360EM "The Flyer"
http://www.mattsrv6.com - Matt's RV-6 Revitalization Log
Status: 118+ Hours Since Purchase - Upgrades Complete; Now In Full Flyer Mode


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List

_________________
Matt Dralle
Matronics Email List Administrator
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Speedy11(at)aol.com
Guest





PostPosted: Sun Aug 26, 2012 12:46 pm    Post subject: Battery Installation and Wire Routing Provisions Reply with quote

Stan,
I've documented all of your questions on my web site. I ran cables in every possible niche.
I have the IO-390, MT CS 3 blade, one battery in the lower front baggage and one under the aft baggage shelf. My plane is not nose heavy at all - solo or dual.
Mine was a QB and installation of the forward battery was not difficult, just time consuming.
Contact me offline if you'd like links to the photos showing the areas you have questions about.
Regards,
Stan Sutterfield
speedy11(at)aol.com (speedy11(at)aol.com)


In a message dated 8/26/2012 3:08:52 A.M. Eastern Daylight Time, rv8-list(at)matronics.com writes:
Quote:
I=99m looking for feedback on adding wire routing holes to F-806B
and F-807A. Specifically, I could use an additional set on the right
side so that I can route the transponder antenna cable under the floor.
I have the one set, matching the left side battery cable routing holes,
which I intend to use for ADAHRS and A/P pitch servo cable wire routing.
I=99m planning 1 ea. 5/8=9D dia. hole in F-806B at
2.5=9D outboard of the rudder cable hole and just outboard of the
F-813R-1 Seat Rib in F-807. Van=99s has no comment. Guess the
builder mod=99s here have been too many and varied to analyze each
one. I=99m more than willing to go on past experience.

Also question re battery installation. I=99m going with an O-360
and 3-bladed Catto prop, so I think a forward battery makes sense. Was
looking at the lower right side of the baggage compartment, but that
looks next to impossible in a QB. Has anyone else done that?

Thanks in advance for any and all comments.

Stan Loer
RV-8 QB
stazel(at)cpros.com

[quote][b]


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List
Back to top
Michael Wynn



Joined: 10 Jan 2006
Posts: 148
Location: San Ramon, CA

PostPosted: Mon Aug 27, 2012 5:31 pm    Post subject: Battery Installation and Wire Routing Provisions Reply with quote

Hi Stan,

I would have used the right lower baggage compartment had I thought about it early enough. I couldn't figure out how to mount the battery securely after having riveted up the floors.

On the cables in back, I drilled a couple of holes, made doublers for the bulkheads and think it is pretty secure. I do have a tendency to over build things, so my bird will not be the lightest. Let me know what you decide.

Regards,

Michael Wynn
RV 8 Finishing
San Ramon, CA

In a message dated 8/25/2012 2:54:48 P.M. Pacific Daylight Time, stazel(at)cpros.com writes:
Quote:
I’m looking for feedback on adding wire routing holes to F-806B and F-807A. Specifically, I could use an additional set on the right side so that I can route the transponder antenna cable under the floor. I have the one set, matching the left side battery cable routing holes, which I intend to use for ADAHRS and A/P pitch servo cable wire routing. I’m planning 1 ea. 5/8” dia. hole in F-806B at 2.5” outboard of the rudder cable hole and just outboard of the F-813R-1 Seat Rib in F-807. Van’s has no comment. Guess the builder mod’s here have been too many and varied to analyze each one. I’m more than willing to go on past experience.

Also question re battery installation. I’m going with an O-360 and 3-bladed Catto prop, so I think a forward battery makes sense. Was looking at the lower right side of the baggage compartment, but that looks next to impossible in a QB. Has anyone else done that?

Thanks in advance for any and all comments.

Stan Loer
RV-8 QB
stazel(at)cpros.com

Quote:


="http://www.matronics.com/Navigator?RV8-List">http://www.matronics.com/Navigator?RV8-List
s.matronics.com/">http://forums.matronics.com
p://www.matronics.com/contribution">http://www.matronics.com/contribution


[quote][b]


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List

_________________
Michael Wynn
RV 8
San Ramon, CA
Back to top
View user's profile Send private message
carl.froehlich(at)verizon
Guest





PostPosted: Tue Aug 28, 2012 3:05 pm    Post subject: Battery Installation and Wire Routing Provisions Reply with quote

I have two Odyssey PC-625 batteries, one mounted on one each side about 6’ behind the firewall.  The fuel pump is moved off the floor and mounted vertically to the bulkhead on the left side so the battery can be mounted to the floor.  Running with a 180HP IO-360 and Hartzell CS prop.  This has work out well for me and at least two other RV-8 builders.

Carl

From: owner-rv8-list-server(at)matronics.com [mailto:owner-rv8-list-server(at)matronics.com] On Behalf Of MLWynn(at)aol.com
Sent: Monday, August 27, 2012 9:31 PM
To: rv8-list(at)matronics.com
Subject: Re: Battery Installation and Wire Routing Provisions

Hi Stan,



I would have used the right lower baggage compartment had I thought about it early enough. I couldn't figure out how to mount the battery securely after having riveted up the floors.



On the cables in back, I drilled a couple of holes, made doublers for the bulkheads and think it is pretty secure. I do have a tendency to over build things, so my bird will not be the lightest. Let me know what you decide.



Regards,



Michael Wynn

RV 8 Finishing

San Ramon, CA



In a message dated 8/25/2012 2:54:48 P.M. Pacific Daylight Time, stazel(at)cpros.com (stazel(at)cpros.com) writes:
Quote:

I’m looking for feedback on adding wire routing holes to F-806B and F-807A. Specifically, I could use an additional set on the right side so that I can route the transponder antenna cable under the floor. I have the one set, matching the left side battery cable routing holes, which I intend to use for ADAHRS and A/P pitch servo cable wire routing. I’m planning 1 ea. 5/8” dia. hole in F-806B at 2.5” outboard of the rudder cable hole and just outboard of the F-813R-1 Seat Rib in F-807. Van’s has no comment. Guess the builder mod’s here have been too many and varied to analyze each one. I’m more than willing to go on past experience.



Also question re battery installation. I’m going with an O-360 and 3-bladed Catto prop, so I think a forward battery makes sense. Was looking at the lower right side of the baggage compartment, but that looks next to impossible in a QB. Has anyone else done that?



Thanks in advance for any and all comments.



Stan Loer

RV-8 QB

stazel(at)cpros.com (stazel(at)cpros.com)


Quote:
="http://www.matronics.com/Navigator?RV8-List">http://www.matronics.com/Navigator?RV8-Lists.matronics.com/">http://forums.matronics.comp://www.matronics.com/contribution">http://www.matronics.com/contribution
0
Quote:
1
Quote:
2
Quote:
3
Quote:
4
Quote:
5
Quote:
6
Quote:
7
Quote:
8
Quote:
9
Quote:
="http://www.matronics.com/Navigator?RV8-List">http://www.matronics.com/Navigator?RV8-List
0
Quote:
="http://www.matronics.com/Navigator?RV8-List">http://www.matronics.com/Navigator?RV8-List
1
Quote:
="http://www.matronics.com/Navigator?RV8-List">http://www.matronics.com/Navigator?RV8-List
2
Quote:
="http://www.matronics.com/Navigator?RV8-List">http://www.matronics.com/Navigator?RV8-List
3
[quote][b]


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV8-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group