Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Renewing old data . . .

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> AeroElectric-List
View previous topic :: View next topic  
Author Message
nuckolls.bob(at)aeroelect
Guest





PostPosted: Mon Oct 01, 2012 7:20 am    Post subject: Renewing old data . . . Reply with quote

A few days ago there was some discussion about heated
pitot tubes and some ideas about directly heated tubes
as opposed to assemblies with embedded heating elements.

I was trying to recall some things I explored in
years past . . . a bit fuzzy so I went to the bench and
did the following exploration.

[img]cid:.0[/img]

Dug out my Weller 8400, a descendant of the very first soldering
tool I ever purchased (from Burnstein-Applebee in KC for about
$5). The snap-on ammeter showed just over 300 amps in the 'tip wire'
while the trusty John Fluke multimeter gave me 250 millivolts as
the potential delivered to the tip.

The snap-on confirmed a 120VAC current draw of 1.2A or right
at 140 watts power consumed.

Measurement of the tip material confirmed that the cross-section
was on a par with 10AWG wire . . . I used to make replacement
tips from 10AWG scrap provided by a journeyman electrician up
the street from my house.

The experiment confirmed my recollection that soldering guns
are horribly inefficient tools. The actual heating power
delivered to the working tip is tiny compared to the total
power consumed. My Metcal irons deliver a much greater proportion
of their power to the tip . . . a 30W Metcal will install terminals
on 2AWG wire! The Weller 8400 puts about .250 x 310 or 75 watts
of total consumption into the tip wire . . . and that's spread
all along the tip's length. Local heating at the tip plus conduction
from behind the tip might put half the total heat to good use?

In the case of a directly heated pitot tube, the feature that
gives a soldering gun such poor marks turns out to be exactly
what the DHPT needs . . . hot on every surface prone to collection
of ice that would render IAS inoperable.

Food for thought . . .


Bob . . .


- The Matronics AeroElectric-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?AeroElectric-List



cfd1446.jpg
 Description:
 Filesize:  190.83 KB
 Viewed:  684 Time(s)

cfd1446.jpg


Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> AeroElectric-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group