IFLYSMODEL(at)aol.com
Guest
|
 Posted: Sat Mar 30, 2013 2:47 pm Post subject: CONVERTING AN EARLY HYDRAULIC LIFTER ENGINE BACK TO SO... |
 |
|
Hey Mike: After two episodes of lifter problems, two sets of new lifters, including new camshaft, I am in the middle of a top overhaul and conversion to solid lifters. (3300 SN 1712) I am putting in the original solid lifter camshaft, & intend to use Chevy small block solid lifters (.842 diameter) My engine has a total time of less than 430 hours & other problems I do not care to delve in to.
Each is on his/her own concerning our experimental Jabiru engines.
Lynn
In a message dated 3/30/2013 12:09:19 P.M. Eastern Daylight Time, mymvagusta(at)yahoo.com writes:
| Quote: |
[b]I'm putting a call-out to see if anyone else is (or has already) undertaking
the project of CONVERTING AN EARLY HYDRAULIC LIFTER ENGINE
(supplied with the original solid-lifter cam) -- BACK TO SOLID LIFTERS.
I know of five others, but would like to see if there are more out there.
I will be going this route and am in the “information gathering” stage.
Thanks for the help,
Mike
mymvagusta(at)yahoo.com (mymvagusta(at)yahoo.com)
[/b]
|
[quote][b]
| | - The Matronics JabiruEngine-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?JabiruEngine-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
