 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
flying-nut(at)cfl.rr.com
Guest
|
 Posted: Sun Jun 16, 2013 11:57 am Post subject: Fwd: RE: Routing electrical conduit |
 |
|
I ran my conduit straight forward like picture #8 on both sides (step
drill works nice here) and made a side panel cover out of some thin
aluminum I had laying around. Some PEM nuts/screws hold the side panel
on. I don't use the long angled piece at all.
Linn
The attached photos are the only ones I can find that have more detail. The
conduit ends after it goes forward through the side rib lighting holes (the
ones where I installed the large grommets). Forward of that the runs just
use snap bushings like Van's has in his plans. I think I had to add one
additional hole on one side.
Note - there is no way to get all the wires and such past the panel bulkhead
just using the left side (with the supplied cover plate) per the planes. I
ran a 1" or so wire bundle up the inside of the last right side rib then
past the panel bulkhead in the side channel. I slightly enlarged the panel
notch that straddles the side channel for added clearance. I used some
plastic mesh conduit for this run. Most of it is hidden behind the little
side cover plate (photos #8 & #9).
Carl
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
| Description: |
|
| Filesize: |
253.72 KB |
| Viewed: |
1359 Time(s) |
|
| Description: |
|
| Filesize: |
300.26 KB |
| Viewed: |
1359 Time(s) |
|
| Description: |
|
| Filesize: |
300.59 KB |
| Viewed: |
1359 Time(s) |
|
| Description: |
|
| Filesize: |
296.76 KB |
| Viewed: |
1359 Time(s) |
|
|
|
| Back to top |
|
 |
johngoodman
Joined: 18 Sep 2006
Posts: 530
Location: GA
|
| Posted: Mon Jun 17, 2013 5:56 am Post subject: Re: Fwd: RE: Routing electrical conduit |
|
|
Why is this a separate thread?
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
_________________
#40572 Phase One complete in 2011 |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
