dfritz(at)bpgsim.com
Guest
|
 Posted: Tue Jul 02, 2013 8:03 am Post subject: Fwd: Re: Things needed for the build |
 |
|
I would add my vote for the Cleveland angle drill kit and second the
recommendation for the Cleveland hand squeezer. While I have been happy
with my tools from Avery (I also have some from Cleveland), I wish I had
purchased both of these items from Cleveland. The squeezer is easier to
use and the angle drill kit head is much smaller and will fit in tighter
places.
Dave Fritzsche
RV-10 N965DF
Fuselage, Finishing
Take a look at the Avery or Cleaveland RV toolkits on their websites and subtract out the things you already have.
Extras I purchased over time:
tungsten bucking bar (best tool purchase I made)
pneumatic squeezer
additional 300 or so 3/32 (silver) clecos
extra #30 & #40 bits
long #10 & #12 bits
long backrivet set
.2495 & .311 reamers
odd ball bits (#27, #28, #31)
tube flaring tool
tube bending tool
tank 3/32 dimple dies
safety wire pliers
I already had a Dremel, but I highly recommend one. For a hand squeezer, I also recommend Cleaveland's "Main Squeeze" with at least a 3" yoke and a longeron yoke.
--------
Todd Stovall
aka Auburntsts on EAA, AOPA, Purple Pilots, VAF, and RVairspace
RV-10 N728TT
Empacone, Wings, Fuse, Finishing
www.mykitlog.com/auburntsts
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=403798#403798
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
