Matronics Email Lists :: View topic - Detaching the Fuel Tank

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Detaching the Fuel Tank

Matronics Email Lists Forum Index -> RV6-List

View previous topic :: View next topic

Author Message

genie(at)swissmail.org
Guest

Posted: Mon Nov 28, 2011 1:37 pm Post subject: Detaching the Fuel Tank

Does anyone know how I can detach or remove the fuel tanks from the 

wings? I unscrewed the screws on the wing but the tank refuses to budge.



Due to a fuel leak I need to remove the starboard tank. Fuel was 

dripping from the trailing edge of the wing root.



Thanks.



George Nielsen

RV-6 PH-XGN

The Hague, the Netherlands

- The Matronics RV6-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV6-List

Matt Dralle
Site Admin

Joined: 08 Nov 2005
Posts: 26321
Location: Livermore CA USA

Posted: Mon Nov 28, 2011 2:12 pm Post subject: Detaching the Fuel Tank

At 01:34 PM 11/28/2011  Monday, you wrote:

 	  Quote: 	
		  



Does anyone know how I can detach or remove the fuel tanks from the wings? I unscrewed the screws on the wing but the tank refuses to budge.



Due to a fuel leak I need to remove the starboard tank. Fuel was dripping from the trailing edge of the wing root.



Thanks.



George Nielsen

RV-6 PH-XGN

The Hague, the Netherlands


	




Hi George,



I think there might be a hand full of AN3 bolts that you'll have to remove from the aft side of the spar before you can drop the fuel tank.  On the RV-8, there were a lot of bolts.  A lot.  I can't remember if the -6/-4 have the same arrangement, but it would stand to reason.

-

Matt "Red Dawg" Dralle



RV-8 #82880 N998RV "Ruby Vixen"

http://www.mattsrv8.com - Matt's Complete RV-8 Construction Log

http://www.mattsrv8.com/Mishap - Landing Mishap Rebuild Log

http://www.youtube.com/MattsRV8 - Matt's RV-8 HDTV YouTube Channel

Status: 170+ Hours TTSN - Rebuilding Fuselage After Landing Mishap...



RV-6 #20916 N360EM "The Flyer"

http://www.mattsrv6.com - Matt's RV-6 Revitalization Log

Status: 18 Hours Since Purchase - Upgrades Complete; Now In Full Flyer Mode

- The Matronics RV6-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV6-List

_________________
Matt Dralle
Matronics Email List Administrator

info(at)bigskymartialarts
Guest

Posted: Mon Nov 28, 2011 2:14 pm Post subject: Detaching the Fuel Tank

Took mine off a couple of months ago, just have to wiggle it the sheet metal

pinches down on the inner metal, make sure you have the fuel lines, fuel

sending wires disconnected, and the wing to fuselage trim metal off.

John Paul

RV-6 N91CM



--

- The Matronics RV6-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV6-List

HCRV6(at)comcast.net
Guest

Posted: Mon Nov 28, 2011 5:24 pm Post subject: Detaching the Fuel Tank

Remove the wing to fuselage fairing and remove the single AN-5 bolt in the tank to fuselage fitting at the front of the inboard tank rib, plus all fuel lines and tank sender electrical leads,  Then just wiggle and pull.  It takes some effort to lift the dimples in the tank skins out of their countersinks.



Harry Crosby

RV-6 N16CX, 913 hours

From: "George Nielsen" <genie(at)swissmail.org>

To: rv6-list(at)matronics.com

Sent: Monday, November 28, 2011 1:34:00 PM

Subject: Detaching the Fuel Tank



--> RV6-List message posted by: George Nielsen <genie(at)swissmail.org>



Does anyone know how I can detach or remove the fuel tanks from the 

wings? I unscrewed the screws on the wing but the tank refuses to budge.



Due to a fuel leak I need to remove the starboard tank. Fuel was 

dripping from the trailing edge of the wing root.



Thanks.



George Nielsen

RV-6 PH-XGsp;                     &===





 [quote][b]

- The Matronics RV6-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV6-List

hlbartel(at)pld.com
Guest

Posted: Mon Nov 28, 2011 5:39 pm Post subject: Detaching the Fuel Tank

After you remove all screws from the upper and lower surface, you must also remove the AN3 bolt at the wing root, where it attaches to the fuselage.� Fuel line needs removed, and after carefully sliding the tank forward, you should be able to roll the tank (leading edge up) and turn the outboard end aft, and remove the wire to the fuel sending unit.

  �

 Good Luck,

 Harry Bartel

 On Mon, Nov 28, 2011 at 3:34 PM, George Nielsen <genie(at)swissmail.org (genie(at)swissmail.org)> wrote:

 [quote]--> RV6-List message posted by: George Nielsen <genie(at)swissmail.org (genie(at)swissmail.org)>

 

Does anyone know how I can detach or remove the fuel tanks from the wings? I unscrewed the screws on the wing but the tank refuses to budge.



Due to a fuel leak I need to remove the starboard tank. Fuel was dripping from the trailing edge of the wing root.

 

Thanks.



George Nielsen

RV-6 PH-XGN

The Hague, the Netherla======================9;s Terrific Free Incentive Gifts provided

 � � * The Builder's Bookstore www.buildersbooks.com

 s.com/contribution" target="_blank">http://www.matronics.com/contribution

 � � � � � � � � � � � � � � �-Matt Dralle, Li===========================================

_-= � � � � �- The RV6-List Email Forum -

 :

 -List" target="_blank">http://www.matronics.com/Navigator?RV6-List==========================================

  http://forums.m======================� �-Matt Dralle, List Admin.

 ================================



 [b]

- The Matronics RV6-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV6-List

ceengland(at)bellsouth.ne
Guest

Posted: Mon Nov 28, 2011 5:43 pm Post subject: Detaching the Fuel Tank

I used 'popsicle' sticks (available at craft stores) to hold the     tank flanges off the spar while pulling it off; it helps keep the     skin dimples from scratching the spar flange.

     

     On my -4, I had to pull the fuel line back into the fuselage so the     root end of the tank could be pulled forward.

     

     Charlie

     

     On 11/28/2011 07:21 PM, HCRV6(at)comcast.net (HCRV6(at)comcast.net) wrote:     [quote]       p { margin: 0; }       Remove the wing to fuselage fairing and remove the single         AN-5 bolt in the tank to fuselage fitting at the front of the         inboard tank rib, plus all fuel lines and tank sender electrical         leads,  Then just wiggle and pull.  It takes some effort to lift         the dimples in the tank skins out of their countersinks.

         

         Harry Crosby

           RV-6 N16CX, 913 hours

         

         

         From: "George Nielsen"         <genie(at)swissmail.org> (genie(at)swissmail.org)

         To: rv6-list(at)matronics.com (rv6-list(at)matronics.com)

         Sent: Monday, November 28, 2011 1:34:00 PM

         Subject: Detaching the Fuel Tank

         

         --> RV6-List message posted by: George Nielsen         <genie(at)swissmail.org> (genie(at)swissmail.org)

         

         Does anyone know how I can detach or remove the fuel tanks from         the 

         wings? I unscrewed the screws on the wing but the tank refuses         to budge.

         

         Due to a fuel leak I need to remove the starboard tank. Fuel was         

         dripping from the trailing edge of the wing root.

         

         Thanks.

         

         George Nielsen

         RV-6 PH-XGsp;                     &===

         

       

     [b]

- The Matronics RV6-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV6-List

rv6(at)att.net
Guest

Posted: Mon Nov 28, 2011 7:45 pm Post subject: Detaching the Fuel Tank

I have removed both tanks on my RV6 and it was definitely difficult.  One tank came off eventually using the wiggle and pull technique, but the other wouldn't come off.  I think some proseal was holding it on.  I took a small  "L" shapped pry bar( about 12") and put a piece of rubber hose on the small end.   I put a piece of aluminum against the spar face to pry against and put the hose end of the bar between the spar face and tank baffle.  After prying GENTLY it forced the tank forward and freed it loose.  

   

Jerry Calvert  

RV6  

Edmond OK  

       

From: owner-rv6-list-server(at)matronics.com [mailto:owner-rv6-list-server(at)matronics.com] On Behalf Of Charlie England

 Sent: Monday, November 28, 2011 7:41 PM

 To: rv6-list(at)matronics.com

 Subject: Re: Detaching the Fuel Tank  

  

  

   

I used 'popsicle' sticks (available at craft stores) to hold the tank flanges off the spar while pulling it off; it helps keep the skin dimples from scratching the spar flange.

 

 On my -4, I had to pull the fuel line back into the fuselage so the root end of the tank could be pulled forward.

 

 Charlie

 

 On 11/28/2011 07:21 PM, HCRV6(at)comcast.net (HCRV6(at)comcast.net) wrote:     

Remove the wing to fuselage fairing and remove the single AN-5 bolt in the tank to fuselage fitting at the front of the inboard tank rib, plus all fuel lines and tank sender electrical leads,  Then just wiggle and pull.  It takes some effort to lift the dimples in the tank skins out of their countersinks.    

Harry Crosby

 RV-6 N16CX, 913 hours  

  

       

  

From: "George Nielsen" <genie(at)swissmail.org> (genie(at)swissmail.org)

 To: rv6-list(at)matronics.com (rv6-list(at)matronics.com)

 Sent: Monday, November 28, 2011 1:34:00 PM

 Subject: Detaching the Fuel Tank

 

 --> RV6-List message posted by: George Nielsen <genie(at)swissmail.org> (genie(at)swissmail.org)

 

 Does anyone know how I can detach or remove the fuel tanks from the 

 wings? I unscrewed the screws on the wing but the tank refuses to budge.

 

 Due to a fuel leak I need to remove the starboard tank. Fuel was 

 dripping from the trailing edge of the wing root.

 

 Thanks.

 

 George Nielsen

 RV-6 PH-XGsp;                     &===  

  

    	  Quote: 	
		    	
<www.buildersbooks.comwww.homebuilthelp.comhttp://www.matronics=================[/b][/quote]http://forums.matronics.com[/url]         - List Contribution Web generous nbsp;           �            --> http://www.matronics.com/c=[/b] [b]

- The Matronics RV6-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV6-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV6-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum